Classicbond Contact Adhesive

Classicbond Contact Adhesive from Rubbercover Ltd

By: Rubbercover Ltd  16/08/2014
Keywords: rubbercover, Classicbond, contact-adhesive

Contact adhesive used for adhering Classicbond One Piece Rubber Roofing Membranes to non timber surfaces, upstands and around perimeter of roof. Used For: Rubber Roofing adhesive used for adhering rubber roofing membrane to most materials. Used on up-stands and vertical surfaces or old Felt Size: 1.0 Litres (Coverage 1 to 2 sqm) Size: 2.5 Litres (Coverage 4 to 5 sqm) Size: 5.0 Litres (Coverage 7 to 10 sqm) Size: 10 Litres (Coverage 15 to 20 sqm) Coverage: 0.5 Ltr / m2 when applied to both sides (depending on surfaces) Application Up-stands: Use a 4" mini roller to apply contact adhesive to both the up-stand and rubber roofing membrane. It is also good practice to secure the membrane to the deck perimeter with a 150mm width strip of contact adhesive. This will stop the membrane from lifting due to shrinkage. Ensure that the contact adhesive is touch dry before rolling the membrane onto the substrate/up-stand. Application Non-Permeable Deck: Using a sheepskin roller apply contact adhesive to both the deck and underside of membrane evenly. Ensure that the contact adhesive is touch dry before rolling the membrane onto the deck. Note It is not possible to re-position the membrane once stuck down using contact adhesive. Installation Tip: Allow approximately 5-20 minutes for the contact adhesive to become touch dry dependant on weather conditions. If the membrane is bonded whilst the contact adhesive is still wet you may notice air bubbles appearing under the membrane. These will disappear within a short period of time due to the rubber roofing membrane being partially breathable. www.rubbercover.co.uk

Keywords: Classicbond, contact-adhesive, epdm adhesive, rubbercover,

Other products and services from Rubbercover Ltd

Sure-Edge Rubbercover Flat Roof Trims from Rubbercover Ltd thumbnail
16/08/2014

Sure-Edge Rubbercover Flat Roof Trims

Sure Edge Plastic Edge Trims Sure Edge Plastic Edge Trims Edging trims for any roof, big or small Sure Edge


Flat Roof Metal Edge Trims from Rubbercover Ltd thumbnail
16/08/2014

Flat Roof Metal Edge Trims

Trims to go with our EPDM Rubber Membrane Plastisol Coated Metal Trims - Cost effective, 3m long, available in


16/08/2014

Classicbond Contact Adhesive

Contact adhesive used for adhering Classicbond One Piece Rubber Roofing Membranes to non timber surfaces, upstands and around perimeter of


Classicbond Water Based Adhesive from Rubbercover Ltd thumbnail
16/08/2014

Classicbond Water Based Adhesive

EPDM Water Based Deck Adhesive, EPDM roof adhesive Water Based Adhesive for bonding EPDM to roof decking. 2.5 litres (Coverage


Rubbercover-Classicbond EPDM For flat roofing from Rubbercover Ltd thumbnail
16/08/2014

Rubbercover-Classicbond EPDM For flat roofing

The finest quality easy to fit Flat Roofing material on the UK market for both DIY and Trade users. Rubbercover-Classicbond from £6.99 per square metre. Proven to last 50+ years. Instruction videos onsite along with simple ordering for next day delivery www.rubbercover.co.uk